Rough Cut Laser Engraving Slate Sign

16mm linear PCB mounting potentiometer. Carbon track with serrated shaft.

Mechanical specification

Rotational angle = 300degrees; (+/-5deg;)

Rotational life = 15000 cycles Electrical specification

Carbon track Rated power = 0.125W

Maximum voltage = 200Insulation resistance = 100MA at 500V DC

This 5mm (Cast) Acrylic Sheet measures 600mm x 400mm. The surface of the sheet has a high gloss finish. Clear Acrylic sheets will allow light to pass through clearly, enabling objects to be distinguished through the material with virtually no colour bias

Excellent value for money.

High gloss surface.

Very high light transmission.

Easily laser cut, drilled and thermoformed.

These sheets can be used as an alternative to glass as they have very good mechanical properties.

Length: 600mm.

Width: 400mm.

Thickness: 5mm (nominal).

These stylish high quality natural rough-cut vertical slate signs, measuring 200mm x 150mm, look great hanging in a window, on a wall or anywhere else you might care to put up a sign. Not only do they look stylish and sleek, but they are also durable, and practical, and will naturally draw the eye wherever they are put. Although stone/slate cannot be cut with a CO2 laser, they can be laser engraved, which makes for a unique long-term sign. They can also be written on with chalk for information of a more temporary nature, when done just give them a wipe with warm water, with a touch of detergent if heavily soiled, and they are as good as new. Supplied as a pack of 1.

Made from natural slate these stylish signs will maintain their look long-term, but if they do start to fade with age, they can be brought back to life with a little olive oil. Alternatively, a coat of lacquer can really make a difference to the hue, though we are still determining if this will make use with chalk less than perfect. A coat of lacquer, prior to laser engraving, will also help to improve the contrast of the laser engraving.

These stylish high-quality natural rough-cut vertical slate signs will look great in any location.

They are durable, practical, and resistant to scratching and staining.

Personalise them with CO2 laser engraving, a coat of lacquer will help improve the contrast.

They can easily be wiped clean with warm water, or warm water mixed with a small amount of mild detergent.

The perfect gift for someone special!

If they fade over time they can easily be brought back to life with a little olive oil.

An even coat of lacquer can have a dramatic positive effect on their look.

1 x Rough Cut Laser Engraving Slate Signs - with holes 200mm x 150mm.

This is a high-quality AB/AB Italian Panguaneta Poplar Plywood sheet (laserply) that is suitable for a wide range of applications and is particularly suited to laser cutting. Panguaneta manages its own woodlands, so it knows that every last sheet has been produced responsibly, sustainably, and to the highest of standards. This Poplar Plywood has an AB/AB grading which is typically the best grade of plywood available. Poplar has a lower density than Birch, meaning that it can be easily laser cut at lower power settings

This plywood uses an EN314-2 Class 1 glue which is suitable for Interior (dry) conditions. Interior glue is generally considered the preferred option for materials that are to be laser cut. This is because the exterior glues can cause a more obvious 'burnt' look on and around the area that is cut. Poplar is a cultivated wood that grows quickly, which makes it a very sustainable product.

Low-density poplar plywood sheet (laserply) for easier laser cutting.

Top-quality AB/AB grading meaning fewer knots aiding consistency of laser cutting.

Interior grade glue.

Dimensions: Length: 400mm, Width: 300mm, Height: 4mm.